|  |  External Oil Cooler Filter Mount
If you race your 91-99 DSM, you might find the factory water-to-oil cooler (it's hidden inside your oil filter housing) is inadequate for the heat load the car is seeing. An external air-to-oil cooler can help, but it can be difficult to mount lines, since there is no easy place to tap the lines into.
Our solution is an oil filter mount that is made for an external oil cooler. We have one for both six-bolt seven-bolt cars. ("Six-bolt" and "Seven-bolt" refer to the flywheel bolt pattern. The changeover happened in May of '92. If you're not sure which engine you have, call us.) 1990 models already have an external cooler!
This is a genuine Mitsubishi part -- the 7-bolt model (pictured) is sourced from the Lancer Evo parts bin! Bolts directly on in place of your factory oil filter mount.
Oil cooler not included; those are available from a variety of sources, and can be sized to fit your needs.
|
| | | | External Oil Cooler Filter Mount - Seven-bolt motor
Lancer Evolution original part!
Note: These are becoming increasingly harder and harder to get. Please be patient when ordering as we only can get a one or two at a time from our Japanese shipments.
| | | OEM Crush Washers for External Oil CoolerThese aren't your typical crush washers. They have a rubber type ring on the inside to help seal it. Brand new right from Mitsubishi. Sold as a set of 4 washers. If you are upgrading to AN fittings all you need is one kit. If you are still using the banjo style fittings you will need 2 kits to replace all 8.
| | | Metric to -8AN Adapter for External Oil CoolerThis is the hard to find metric to AN adapter to go into the OEM external oil cooler mounts that are available above. It allows you to then use any oil cooler you want and put it anywhere you want utilizing -8 AN lines. Don't use a 1/2" NPT to -8AN adapter which you will have to jamb into the housing ruining the threads and potentially allowing for a leak.
Sold as a set of 2.
| | | Oil Filter Housing GasketPicked up a new oil filter housing to run an external oil cooler? Maybe you just had it off while doing a balance shaft elimination. Regardless, get a new OEM gasket when putting it all together. Select engine type below. Fits 4G63 engines.
| |
|
|
| |